Package Scripts

You can define a struct in your box.json called scripts that correspond to the interception points in CommandBox. Any script defined there will be ran on during that interception point. This allows you to prescribe arbitrary commands on a package-by-package basis. You may wish to set your package location any time you bump a package version or perform a !git push on publish. Below is an example of some scripts in a box.json.

{
  "name" : "My Package",
  "slug" : "my-package",
  "version" : "1.0.0",
  "scripts" : {
   "postVersion" : "package set location='gitUser/gitRepo#v`package version`'",
   "postPublish" : "!git push --follow-tags"
  }
}

Package scripts can be named after any valid interception point and can contain any valid command that you can run from the interactive shell.

Ad-hoc package scripts

You can also create ad-hoc scripts with arbitrary names that contain a collection of often-run commands.

{
  "name" : "My Package",
  "slug" : "my-package",
  "version" : "1.0.0",
  "scripts" : {
   "build" : "!grunt build && testbox run && run-script generateAPIDocs && bump --patch && publish",
   "generateAPIDocs" : "docbox generate"
  }
}

Call these scripts at any time with the run-script command

run-script generateAPIDocs
run-script build

pre/post package scripts

Before any package script is run, CommandBox will look for another package script with the same name, but prefixed with pre. After any package script is run, CommandBox will look for another package script with the same name, but prefixed with Post. So if you have a package that contains 3 package scripts: foo, preFoo, and postFoo, they will run in this order.

1. preFoo

2. foo

3. postFoo

This works for built-in package script names as well as as doc package scripts. It also works on any level. In the example above, if you created a 4th package script called prePreFoo, it would run prior to preFoo.